FAQ - Frequently Asked Questions

To treat moss or lichen, apply treatment and allow a few weeks before staining. Before staining, remove dead material by scraping, scrubbing, or water blasting.

For light mould, there is no need to wash off the treatment if the surface is clean. Leaving it on before painting can aid in long-term control of regrowth.

We recommend using Timber Clean & Prep Decking Preparation. Alternatively, the product 30 Seconds ONE STEP (green label) mixed with chlorine bleach (e.g. Janola) has proven successful in treating mould, moss, and lichen.

Mix as follows: Water 4 parts (e.g. 4 litres), One Step (green label) 1 part (e.g. 1 litre), Janola (or other chlorine bleach) ¼ part (e.g. 250 ml).

Yes, AQUALIN Timber Stain is suitable for both interior and exterior timber surfaces.

Ensure the timber surface is clean and free of mould, moss, dirt, and contaminants before application.

Yes, it can be used on previously stained surfaces if they have weathered and become absorbent. Test absorbency with water to ensure suitability.

AQUALIN Timber Stain typically dries within 90 minutes to touch and can be recoated after that time.

Yes, it works well as a primer/sealer on weathered wood surfaces before painting.

Wash equipment with cold water and soap. Rinse with warm, soapy water and laundry detergent to remove any linseed oil residue.

While it can be used on decks, it's not the recommended primary use as it requires longer curing time compared to products specifically formulated for decks. Like Novex Superdeck.

AQUALIN Timber Stain is suitable for absorbent hardwood surfaces but may require longer drying time compared to softwood.

Yes, AQUALIN Timber Stain contains UV-absorbing pigments for added durability and protection against sunlight.

Yes, AQUALIN Timber Stain is suitable for use on rough-sawn, dressed, and softwood timbers.

AQUALIN Timber Stain has a shelf life of several years when stored in cool conditions away from direct sunlight.