Surface Preparation is Key
Ensure timber is clean, dry, and free from dirt, mould, moss, grease, or contaminants.

We strongly recommend using:

• NOVEX TIMBER CLEAN & PREP – for decks

• NOVEX TREAT–IT – for outdoor furniture and general mould/moss removal

​

For new timber:

• Pine: Weather for 8 weeks, then prep with NOVEX cleaner.

• Hardwood: Weather for at least 12 weeks to allow tannins to leach out. Rinse several times and clean before staining.

​

For previously stained or weathered timber:

• Use a stiff bristle brush to remove loose fibres, then clean and prep with the correct NOVEX treatment.

• Avoid steel wool or wire brushes to prevent iron staining.

• Light-medium pressure water blast if needed—avoid heavy blasting which can damage the timber surface.

​

Application Tips

• Apply on a fine day when temperatures are between 5°C–30°C

• Avoid rain within 24 hours of application

• Stir thoroughly with a wide flat stirrer

• Use a brush or applicator pad

• Apply evenly along full board lengths to avoid lap marks

• Only apply as much as the timber can absorb—do not over-apply

• Coat board ends and edges where possible for best results

​

Drying & Recoating

• Touch dry in 24 hours

• Fully cured in 48 hours (longer in humid or cool conditions)

• Allow longer drying time on hardwood or previously sealed surfaces

• Recoat not usually needed, but if applying a second coat, ensure the first coat is completely touch dry and tack-free

Coverage

• Approx. 6–10m² per litre per coat, depending on timber condition and absorbency
  Rough, aged timber will absorb more stain.

Maintenance

• Wash annually (especially after winter) with NOVEX TREAT–IT to remove dirt, salt, and bird droppings

• Reapply every 2–5 summers or when the surface shows signs of wear

• Dressed timbers may need earlier re-application due to initial limited absorption

Clean-up & Safety

• Clean tools with cold water, then hot soapy water

• Do not allow leftover product to enter drains or waterways

• Dry empty containers and dispose of according to local regulations

Product Info

• Gloss Level: Low sheen

• Application Temperature: 5–30°C

• Shelf Life: Several years in unopened containers stored in cool, dry conditions

• Specific Gravity: 1.03 (1.03kg per litre)

• Sizes Available: 250ml, 1L, 4L, 10L

Common Questions

Q: Can I apply ELITE over old oil-based decking oils or mineral oil finishes?
A: Yes – but only if the timber is dry, weathered, and ready for a new coat. The old finish must be well worn. Clean thoroughly and ensure the timber is absorbent before applying ELITE.